{{indexmenu_n>03}}

====== Getting Connected ======

Consider the following before connecting your LaCie Little Big Disk Thunderbolt 2:

  * To reach transfer rates of up to 20Gb/s bi-directional, the Little Big Disk Thunderbolt 2 must be connected to a computer that supports Thunderbolt 2 technology. Connecting the Little Big Disk Thunderbolt 2 to a computer that supports first generation Thunderbolt technology allows for transfer rates up to 10Gb/s bi-directional.
  * A single Thunderbolt 2/Thunderbolt technology daisy chain can have up to seven devices, including the computer (see [[daisy-chain|]] for further information). If your computer supports Thunderbolt 2 technology and you are adding the Little Big Disk Thunderbolt 2 to a daisy chain that includes first generation Thunderbolt devices, make certain that the Little Big Disk Thunderbolt 2 is the first enclosure connected to the computer. You can lose the higher performance offered by Thunderbolt 2 technology if the Little Big Disk Thunderbolt 2 is daisy-chained behind first generation Thunderbolt technology devices.
  * While the ports on the back of the Little Big Disk Thunderbolt 2 can easily seat older Mini DisplayPort cable ends, Thunderbolt 2 storage will only work when connected to a computer that supports Thunderbolt 2 technology or first generation Thunderbolt technology. Additionally, a cable that supports Thunderbolt technology is required to connect the Little Big Disk Thunderbolt 2 to a computer.

~~pgbreak~~

===== Attach the stand =====

LaCie recommends attaching the included stand before connecting the Little Big Disk Thunderbolt 2 to your computer. Use the screws and hex key (Allen wrench) shipped with your device when following the instructions below. DO NOT attach the stand while the device is powered on.
  - Locate the following: \\ {{:products:lbd2:ill:lbd2_stand_01.jpg?640|}} \\
  - Slide the stand into its slot on the bottom of the device. \\ {{:products:lbd2:ill:lbd2_stand_02.jpg?550|}} \\ 
  - Fasten the screws using the hex key. \\ {{:products:lbd2:ill:lbd2_stand_03.jpg?350|}}

~~pgbreak~~ 

===== Connect the cables =====

Follow the setup steps in the order they are given to ensure that the volume mounts correctly on your computer.

  - Connect the included Thunderbolt cable to one of the enclosure's Thunderbolt 2 ports. Plug the other end of the cable to a compatible Thunderbolt 2 or first generation Thunderbolt technology port on your computer. The additional interface port on the enclosure can be used to daisy chain compatible devices and displays. \\ {{:products:lbd2:ill:lbd2_connect_01.jpg?500|}} \\ 
  - Connect the included external power supply in the following order:
    - First, to the enclosure's power port. \\ {{:products:lbd2:ill:lbd2_connect_02a.jpg?500|}} \\ 
    - Second, to an outlet. \\ {{:products:lbd2:ill:lbd2_connect_02b.jpg?500|}} \\ 
  - The device will turn on automatically and the volume will mount on the desktop. \\ {{:products:lbd2:ill:lbd2_connect_03.jpg?500|}} 

~~pgbreak~~

===== Receiving power =====

To receive power, the enclosure must be:

  - Connected to a power source via the included power supply
  - Connected to a computer or powered device compatible with Thunderbolt 2 technology or first generation Thunderbolt technology

===== Unmounting the volumes =====

In order to avoid file system corruption, it is important to unmount the volume before turning off the enclosure or disconnecting the interface cable. See [[unmounting|]] for details.