{{indexmenu_n>09}}

====== Manage Disk Failure: Manual Rebuild ======
This section describes the procedure for manually rebuilding a degraded array when Auto-Rebuild is disabled and a dedicated spare drive is not available. You must have at least one unconfigured hard drive in the enclosure to perform the steps below.

~~pgbreak~~

===== Rebuilding a degraded array =====
  - Select the degraded array in the Storage pane. You will recognize the degraded array by its yellow icon. 
  - Roll over the **Operation** tab and select **Rebuild**. \\ {{:products:raid-manager:screenshots:ss-lrm-manual-rebuild-01.jpg?700|}} \\ 
  - LaCie RAID Manager displays hard drives that have not been added to an array. \\ {{:products:raid-manager:screenshots:ss-lrm-manual-rebuild-02.jpg?700|}} \\ 
  - Select a hard drive from the list and choose **Submit**. \\ {{:products:raid-manager:screenshots:ss-lrm-manual-rebuild-03.jpg?700|}} \\ 
  - Choose the Property tab for the array. The Background Activity State shows that the rebuild is running. \\ {{:products:raid-manager:screenshots:ss-lrm-manual-rebuild-04.jpg?700|}} \\