Connect your LaCie NAS to a network.
Step 1: Connect the Ethernet cable and power supply
Connect the Ethernet cable to the Ethernet port on the back of the product and to an available Ethernet port on your router. Refer to your router’s documentation if necessary.
Connect the power supply to a wall outlet and to the product.
LaCie 2big NAS | LaCie 5big NAS Pro |
| |
Step 2: Power on the LaCie NAS
Power on the device.
The front LED will turn on and then begin blinking. The device is ready to be accessed once the LED has turned solid blue. Your LaCie NAS may take up to three minutes to boot.
LaCie 2big NAS | LaCie 5big NAS Pro |
| |
Caution: Only use the AC adapter supplied with your specific LaCie device. Do not use a power supply from another LaCie device or another manufacturer. Using any other power cable or power supply may cause damage to the device and void your warranty. Always remove the AC adapter before transporting your LaCie device. Failure to remove the adapter may result in damage and will void your warranty.
Step 3: Access the LaCie NAS Dashboard
Note: The steps below should be completed by the administrator of the device.
Perform the steps below on a PC/Mac connected to the same network as your LaCie NAS:
Launch your preferred internet browser and type the default address for the LaCie NAS:
The Dashboard administration tool will prompt you to create an administrator password.
You may also change:
Make certain to note your login and password for future use.
Choose
Finish. You will be taken to the Dashboard home page.